Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Bandwith limiter setting
  •  
arifhussaink

Messages: 4
Karma: 0
Send a private message to this user
I am using kwf 6.3.1 build 2906 it doning fine. but a problem only in bandwith limit for sellected user. it will limit the trafic if i use 'APPLY TO ALL TRAFFIC'but when i select 'apply to all axcept the selected address group'than also it is limitting trafic for all users.and when i select 'apply to all selected address group only' than it si not limitting for selected and for othes.
realy i m enjoing using kerio it the BEST. THANKS
REGARDS
Previous Topic: port scan detected
Next Topic: Help: Setting up Kerio WinRoute Firewall 5.0
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Tue Nov 21 11:22:44 CET 2017

Total time taken to generate the page: 0.00332 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.