Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » NAT and filtering certain connection on NAT
  •  
cybersans

Messages: 46
Karma: 0
Send a private message to this user
hello guys. i'm sorry if this kind of question or similar question been asked before in this forum.

here is my setting to makesure NAT/internet sharing works:

http://www.freewebs.com/azuan/gallery/KWF%2DNAT.JPG
for the information:
LAN is group of ip address of lan, which 192.168.0.2-192.168.0.10
Local Area Connection = interface of firewall's NIC
Firewall = this host itself.
ADSL = the dsl interface

my question is, how to i add the rule to filtering some outbound connection for both firewall and other from the LAN? i try to add source=ADSL and destination=host/ip to be blocked

but it doesn't work. and i did source=LAN, Local area connection, firewall and destination=host/ip to be blocked

also doesn't work.

i hope someone have a solution how to make the NAT at the same time implement the filtering based on outbound connection.

thank you

[Updated on: Thu, 20 December 2007 08:34]

  •  
RHarmsen.nl

Messages: 189

Karma: 0
Send a private message to this user
Did you place these new rules above or beneath the NAT rule???
Rules are applied from top to bottom.
  •  
cybersans

Messages: 46
Karma: 0
Send a private message to this user
OK. i put the rules above the rules. and it works Shocked
another question, i just put source=firewall and destination=the blocked hosts. will this rule apply to other pc inside the LAN?

tq.

[Updated on: Thu, 20 December 2007 12:48]

  •  
cybersans

Messages: 46
Karma: 0
Send a private message to this user
ok done! just put the source the same like in the image, and destination is the hostname/ip to blocked. everything work fine and the rule is above of the first rules that allow everything.

- topic closed -
Previous Topic: Kerio WinRoute Firewall 6.4.1 released
Next Topic: Configuration error: Failed to load traffic rule
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Nov 18 11:33:11 CET 2017

Total time taken to generate the page: 0.00350 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.