Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Routing 1 ip to a set port?
  •  
dr_k

Messages: 1
Karma: 0
Send a private message to this user
Any way to make kerio route a set ip (from the internet)connecting to port 21 to, say port 333? This is due to restrictions from an ISP.

dr_k
  •  
Jeff Wadlow (Kerio)

Messages: 193
Karma: 6
Send a private message to this user
Are you trying to have KWF listen on port 333 and translate that to port 21? If so then you would want to create a rule like this:

Source: Internet network
Destination: Firewall
Service: TCP:333
Action: Permit
Translate: Dest NAT: Private IP of FTP server
check the box to translate port to: 21

You may have a problem with the data port with that rule. It might be better to create a service for port 333 and have that service use the FTP protocol inspector. I think you will have to set the FTP server to run on 333 (instead of 21)if you decide to try that option.
Previous Topic: unexpected/untracable shutdown
Next Topic: Routing / Nat / Gateway issue, help appreciated
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Nov 18 07:12:36 CET 2017

Total time taken to generate the page: 0.00430 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.