Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » wireless (Setting up Wireless network new to winroute)

Messages: 1
Karma: 0
Send a private message to this user
I am trying to set up a wireless network. Have winroute installed on ser2003 R2 Box Fresh install. Wireless Card installed I Want winroute to handel wep securty and ssid

is that possible

if not do i just assign the wireless card and ip and route traffic through it

any help would be good


Messages: 2119
Karma: 3
Send a private message to this user
WEP/WPA/etc. security and SSID's are note handled by a router, but by a access point. So that part you'd have to configure somewhere else. On the Wireless NIC perhaps? After that: sure, KWF could route traffic for it.
Previous Topic: Config LOG!
Next Topic: PS3 Online Gaming using kerio winroute problems
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Mon Oct 23 09:55:04 CEST 2017

Total time taken to generate the page: 0.00445 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.