Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » 2 Internet Lines (How to setup routing for two internet lines for simultaneous use?)
  •  
ChinDangShun

Messages: 12

Karma: 0
Send a private message to this user
It's caused by Default Gateway rule of Micro$oft, not by KWF, I think. Only *nix systems can do that.

But with KWF, you can easily config the Static Routes to allow load balancing IPRange-by-IPRange (MS Windows specifications).

As with my network configuration, my office uses 2 Internet lines from 2 different ISPs. I connect them into 2 NICs and a NIC for LAN. In KWF, I config the routes to Internet based on the IPRange that an ISP supplies better. For example, I config the routes in KWF:

- Packets from LAN access 0.0.0.0 go through NIC #1 -> ISP #1 (Default internet line)
- Packets from LAN access 210.245.0.0 go through NIC #2 -> ISP #2
...

The TCP/IP in Windows does not allow routing by TCP/UDP port. So it is only the temporary solution. For a best solution, I think that you can use another "real-time" loadbalancing or fail-over router and lay him between Internet and KWF server. Today, I use this configuration and the Internet speed is nearly doubled!

Good luck.
CHINDANGSHUN
Previous Topic: Cannot open chat
Next Topic: How to Allow couple of websites, Block everything else
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Oct 21 15:47:33 CEST 2017

Total time taken to generate the page: 0.00314 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.