Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » NAT (Nat with Cisco)

Messages: 10
Karma: 0
Send a private message to this user
Hi There,

How do I have to a NAT with a Cisco router as a gateway.

1. the Cisco router has a primary Ip and a secondary Ip . (Public Addresses same NIC)

2. I want to have only 2 nics. ( Wan -> cisco And Lan)

Conclusion I have 2 gateways for the nic connected to Internet.

what is the possible trafic rule for nat?

Thank you

[Updated on: Fri, 26 December 2008 21:22]

Previous Topic: Kerio Winroute Firewall 6.5.2 engine restart every 15 min
Next Topic: Load Balancing & Mutiple DynDNS issue
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Mon Nov 20 14:51:04 CET 2017

Total time taken to generate the page: 0.00337 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.