Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Configure multiple external IP Pool address into local IP
  •  
lansclu

Messages: 43
Karma: 0
Send a private message to this user
Hi all,
Is it possible to map multiple external ip addresses to the WAN NIC to map an external ip to an internal host IP.

As our ISP is given IP pool, basically it can be configured on a cisco router by below command.

ip nat inside source list 101 interface Serial0/0/0 overload
ip nat inside source static 192.168.1.5 208.***.97.208
ip nat inside source static 192.168.1.6 208.***.97.209
ip nat inside source static 192.168.1.7 208.***.97.210
ip nat inside source static 192.168.1.8 208.***.97.211
ip nat inside source static 192.168.1.9 208.***.97.212

So, How to configure the same on a Winroute firewall? If it is possible on winroute FW, then we can use winroute firewall instead of Cisco router 2811.

Thanks & regards,
Lansclu.
  •  
lansclu

Messages: 43
Karma: 0
Send a private message to this user
Hi all,
Is the feature implemented in KWF? Is it not possible?
Anyone from kerio support team? could you please write a comment on this?

As my trial evaluation is going to expire. So please reply.

Thanks a lot.
  •  
Petr Dobry (Kerio)

Messages: 776
Karma: 61
Send a private message to this user
Of course it's possible. Read KWF user manual at http://manuals.kerio.com/kwf/en/sect-traffmanual.html, section NAT with a specified IP address.

[Updated on: Sat, 18 July 2009 10:13]


Petr Dobry
Product Development Manager | Kerio
  •  
lansclu

Messages: 43
Karma: 0
Send a private message to this user
Many thanks Kerio_pedobry,
Will check and revert after testing on KWF.

thanks again.
Previous Topic: redirecting homepage
Next Topic: settings of The Unlock button
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Fri Nov 24 17:49:04 CET 2017

Total time taken to generate the page: 0.00385 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.