Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » kerio route
  •  
azzamsalman

Messages: 61
Karma: -1
Send a private message to this user
how can i route group of (ip)s to wan interface1 and route another group of (ip)s to another wan interface2 in kerio traffic policy
  •  
ajamali

Messages: 100
Karma: 1
Send a private message to this user
مرحبا اخي

شو الي بدك تعمله بالضبط
  •  
azzamsalman

Messages: 61
Karma: -1
Send a private message to this user
لدي خطان adsl واريد عمل loadbalance باستخدام kerio المشكلة أنه دوما يظهر خط من الخطين active والأخر inactive علما أن routtable تأخد واحد من الخطين ك default rout
ما الحل ؟؟؟؟
  •  
azzamsalman

Messages: 61
Karma: -1
Send a private message to this user
i want to make load balance between two adsl links by using kerio but the problem is , kerio takes one of the links as active and the other one as inactive, in addition to that the rout table takes one of the links as default rout >
so how can i solve this ?
Previous Topic: Not able to view the contents of yahoo
Next Topic: Virgin Installer - NAT already present
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Wed Nov 22 00:23:55 CET 2017

Total time taken to generate the page: 0.00354 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.