Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Use wireshark on winroute
  •  
luca.civinini@ctt

Messages: 32
Karma: 2
Send a private message to this user
Hello,
for troubleshooting purpose I often install Wireshark/ ethereal on firewall machines.
But I'm noticing a problem with Kerio. When I start the capture (both on internal and external interface) and ask Wireshark to filter only specific packets, I'm not able to see all packets passing throu the network: namely, I'm missing the OUTBOUND packets (i.e. ones leaving my network towards Internet) while I'm able to see incoming packets.
I suspect this is due to the "level" KWF driver works within Windows protocol stack (KWF driver is at lower level than Wireshark Winpcap service).
Is there a way to enable "full" capture?
Thanks
Previous Topic: Kerio WinRoute Firewall on LINUX!!!
Next Topic: Remote Desktop Connection dropping !!!!
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Tue Oct 17 11:19:30 CEST 2017

Total time taken to generate the page: 0.00400 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.