Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Problem with VIA RHINE III NIC
  •  
rimametal

Messages: 6

Karma: 0
Send a private message to this user
Hi friends,

I recently install two new NIC made by Mikrotik, each of them has 4 ports 10/100Mbps with Via Rhine III controller.
But after some time (between 1 hour to 10 hours) all the ports (or some times just few of them) suddendly disabled (on these two NIC)!!! even you can not ping the modem connected to the interface, and i have to restart the system to have access again, but same story again and again.
I check the same system with other NICs, and work perfectlly without any problem.
Please guide me.

OS: WIN2003 R2 SP2
RAM: 3 GB
HDD: RAID 1, 320 GB
CPU: P4 3.00 Ghz
KWR: 6.7.1 patch 1 or 2 (Same result)
NIC: 2 x 4 Port VIA Rhine III + 2 x Marvel Giga Ports


Am!r
Previous Topic: Yahoo Mail Slow Issue
Next Topic: user accounts
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Thu Nov 23 19:34:00 CET 2017

Total time taken to generate the page: 0.00313 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.