Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » protocol inspector is eating up upload bandwith (protocol inspector is eating up upload bandwith)
  •  
kasjak2000

Messages: 5

Karma: 0
Send a private message to this user
Hey guys,

we have installed Winroute Firewall 6.7.1-6544 x86.
The internet-provider (cable) gives us 250kBytes/s Upload.

I can reach this upload during a 100MByte file http-upload without a http protocol inspector.

With an enabled protocol inspector we have max. 130 kBytes/s.

All settings are minimal, means:
* disabled bandwith limiter,
* disabled antivirus,
* disabled proxy,
* disabled transparent proxy

What can be here wrong?

Best regards
kasjak2000

[Updated on: Wed, 07 April 2010 01:45]

  •  
Nikxx

Messages: 67

Karma: 0
Send a private message to this user
I dont think its about what you can do. When protocol inspector is anabled it does make the connection slower the normal, exatly because it is searching to find any "wrong access" inside that protocol communication.

Lots of virus use this kind of ability to access the internet and also your computer, so, enabling this service will make the connection slower, only because each and every packet is open, scanned and the allowed to go to its destiny.

Cya.
  •  
gantenbein

Messages: 3
Karma: 0
Send a private message to this user
We have exactly the same issue with the protocol inspector and the ftp protocol.
I don't agree with Nikxx because 130KB/s is far to slow with modern processors.

For us the solution was to use the VMware Virtual Appliance. The speed with active protocol inspector increased from 180KB/s to the full line capacity of 32 MBit/s
Previous Topic: Kerio Control 7.0.0 RC 3 released!
Next Topic: Connecting to Dailin VPN trough WinRoute
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sun Sep 24 01:39:53 CEST 2017

Total time taken to generate the page: 0.00471 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.