Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Control VPN and Cisco VPN on same client?
  •  
sbergin

Messages: 66
Karma: 2
Send a private message to this user
Since installing Cisco's VPN client on my MacBook Air running 10.6.6, any attempt to connect from the same MacBook Air to my office using Kerio Control VPN (to my new Kerio Control Box) fails. The Kerio VPN client version is 7.1.0 build 1573. The Cisco VPN client build is 4.9.01 (0100). Please note that I do not have to have the Cisco client running for the Kerio client to fail. I have to force-quit the kvpn daemons, the Disconnect process never completes.

Is this expected behavior??
  •  
sbergin

Messages: 66
Karma: 2
Send a private message to this user
Disregard please. Little Snitch was blocking the ports, but was not presenting the typical dialog box asking permission to allow the ports...
Previous Topic: Software appliance slow proxy browsing
Next Topic: problem with WAN speed
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Fri Nov 24 08:35:35 CET 2017

Total time taken to generate the page: 0.00372 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.