Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Automatic failover
  •  
nhoague

Messages: 853
Karma: 18
Send a private message to this user
Anyone have experience with Control and VMware and HA? We are trying to find a solution to have two Control appliances in a automatic fail over in the event of hardware failure.

Thanks.
  •  
giampos

Messages: 187
Karma: 2
Send a private message to this user
No.....the Vsphere with HA and FT is too expensive !!!
I moved Vmware appliance from one host to another, same config, same network cards, and all was ok.
Previous Topic: Enabling SSH
Next Topic: Where is Uservoice for Kerio Control
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Tue Sep 19 15:34:55 CEST 2017

Total time taken to generate the page: 0.00401 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.