Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Operator » Using WELLGate 3802 with Kerio Operator (WELLGate configuration how-to)
  •  
Vladimir Toncar (Kerio)

Messages: 1696
Karma: 39
Send a private message to this user
Hi,

This post contains a brief configuration how-to for WELLGate 3802/3804.

The WELLGate is a cheap SIP/analog gateway that's relatively easy to configure with Operator.

The pluses and minuses of the device are as follows:
Pluses: cheap, supports 2 (3802) or 4 (3804) analog lines
Minuses: long boot time, no SIP password (so you should run it in a safe network, ideally in a VLAN that's only used for voice traffic)

Vladimir

Previous Topic: Kerio Operator 1.1 - Device cannot REGISTER : Asterisk 1.4 BUG!
Next Topic: SIP TRUNK with multiple numbers
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Wed Nov 22 22:52:54 CET 2017

Total time taken to generate the page: 0.00339 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.