Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Operator » Analog Card support?
  •  
Rolando

Messages: 43
Karma: 0
Send a private message to this user
Does Operator supports analog card on ver 1.2?

Thank you.
  •  
Vladimir Toncar (Kerio)

Messages: 1696
Karma: 39
Send a private message to this user
Operator 1.2 (currently available as RC2) supports the Digium TDM410 analog card.

Vladimir
  •  
JohnS

Messages: 6
Karma: 0
Send a private message to this user
In searching online, I notice the Digium TDM410 analog card has different options. I need to setup a system in my office with two incoming analog lines.

In this case, would I need this card with 2 FXO ports?

Just want to make I don't end up with the wrong card.

Regards,

John Stephen

  •  
Jakub Zeman (Kerio)

Messages: 73

Karma: 1
Send a private message to this user
Hello,

you need Digium TDM410 card with up to four X100M FXO modules.

Jakub
Previous Topic: Recommended Phone Model
Next Topic: two sip want to outgoing with prefix
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Fri Oct 20 10:42:16 CEST 2017

Total time taken to generate the page: 0.00408 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.