Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Operator » Kerio Operator and Cisco ATA 186 and 188
  •  
Scott

Messages: 9
Karma: 1
Send a private message to this user
I am currently looking at migrating my current Cisco based VOIP system to Kerio Operator. All my phones at 7912, 7940, and 7960s which should all work and even auto provision. I do have about 6 Cisco ATA 186 and 188 boxes. I have not seen in the forums or much documentation if these ATAs will work with Operator or not. So my question is will the Cisco ATA 186 and 188 work with Kerio Operator and if so will they auto provision.

Thanks,

Scott
  •  
Vladimir Toncar (Kerio)

Messages: 1696
Karma: 39
Send a private message to this user
Hi,

These adapters are not supported by auto provisioning. They should work if you configure them manually.

Vladimir
  •  
mar99

Messages: 48
Karma: 0
Send a private message to this user
Hi Scott,

is it already working (the ata186)?
so yes can you say wich firmware you use and the configuration?
i'm trying difrent firmwares but i can't register is on the Kerio operator.

thanks.
Previous Topic: cisco spa504, program line button but everything disappear after reboot
Next Topic: Bria registers but not showing in Operator
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Wed Nov 22 00:16:17 CET 2017

Total time taken to generate the page: 0.00372 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.