Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Control + IPv6 + Tunnel Brokers (IPv6 Tunnels)
  •  
silars

Messages: 428
Karma: 59
Send a private message to this user
Although Control doesn't have interface support for IPv6 tunnels (sit tunnels), it does appear everything is there to make it happen easily. I've been playing around with Hurricane Electric's Tunnel Broker (http://tunnelbroker.net/) and found I'm able to create and use an IPv6 tunnel with Kerio...but I have to use SSH and create the tunnel manually.

Once the tunnel is created, Control is then able to configure the tunnel IP addresses, and viola, I'm on the IPv6 Internet. At least, until Control has to reboot. I haven't written the script to do this on startup, but the manual process is so simple I haven't felt the urge.

Are there any plans to incorporate such a simple process into Control? Would seem to be such an easy method to help get folks onto the IPv6 path, and such a cool marketing item.

Anyone else find a better way to do this?
  •  
Timoti

Messages: 1
Karma: 0
Send a private message to this user
Hi,

I'm just asking the same question as Karma but after 2 years now.

Any answers??
  •  
Tomas Chmelar

Messages: 1
Karma: 0
Send a private message to this user
Hi,

In 8.4 version, there is a possibility to setup this in winroute.cfg.
For now, it's tested to be working with tunnelbroker.net

Export configuration + extract and edit winroute.cfg like this:

Find your interface configuration in section

<list name="Interfaces_v2">


and edit those lines:

<listitem>
...
    <variable name="IPv6Enabled">1</variable>
    <variable name="IPv6Addresses">2001:xxxx:xxxx:xxxx::2/64</variable> // Client IPv6 Address + prefix len
    <variable name="IPv6Mode">Tunnel</variable>
    <variable name="IPv6Gateway">2001:xxxx:xxxx:xxxx::1</variable>      // Server IPv6 Address
    <variable name="IPv6TunnelEndpoint">xxx.xxx.xxx.xxx</variable>      // Server IPv4 Address    
...    
  </listitem>


Then save it and import it again.

Note: Edit of this interface in Web administration will break this config and switch interface back to Automatic mode.

Tomas

Previous Topic: Error 1714
Next Topic: Disabling an interface does not shut the interface
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sun May 28 18:37:50 CEST 2017

Total time taken to generate the page: 0.00924 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.