Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Operator » Cisco 7940G only outgoing
  •  
andreag

Messages: 3
Karma: 0
Send a private message to this user
hello guys,
I try to configure Cisco 7940G phone on Kerio Operator and it works in outgoing calls but for ingoing calling Kerio respond that internal phone is offline.

The phone is discovered with Autoprovisioning but status remain in "not registered" and on the internal configuration status is offline.

in the debug i see only:
-- Executing [0312281101@i-voip-eutelia-it-outbound[/email]:1] Macro(\"SIP/i-Eutelia-outbound-00000002\", \"limitMaxCalls\") in new stack
[07/Jun/2012 11:57:58] {sip} Operator asterisk[1539]: VERBOSE[3290]: pbx.c:4108 in pbx_extension_helper: -- Executing [s@macro-limitMaxCalls[/email]:1] GotoIf(\"SIP/i-Eutelia-outbound-00000002\", \"0?congestion\") in new stack
[07/Jun/2012 11:57:58] {sip} Operator asterisk[1539]: VERBOSE[3290]: pbx.c:4108 in pbx_extension_helper: -- Executing [s@macro-limitMaxCalls[/email]:2] Set(\"SIP/i-Eutelia-outbound-00000002\", \"GROUP(maxCalls)=maxCalls\") in new stack

Executing [s<_at_>macro-callPermissions:6] NoOp(\"SIP/i-Eutelia-outbound-00000001\", \"Check permissions of i-Eutelia to dial 10.\") in new stack
[07/Jun/2012 11:55:04] {sip} Operator asterisk[1539]: VERBOSE[3245]: pbx.c:4108 in pbx_extension_helper: -- Executing [s@macro-callPermissions[/email]:7] GotoIf(\"SIP/i-Eutelia-outbound-00000001\", \"0?denied\") in new stack


Someone can able to configure these phones?
thanks very much
Andrea

[Updated on: Thu, 07 June 2012 12:21]

  •  
Vladimir Toncar (Kerio)

Messages: 1696
Karma: 39
Send a private message to this user
Have you done any changes to the call permissions of the SIP interface?
Previous Topic: rewrite caller ID based on chosen extension
Next Topic: Kerio Operator 2.0.0 Beta 3
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Thu Aug 24 01:02:35 CEST 2017

Total time taken to generate the page: 0.00400 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.