Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » how to filter IP identifier in KWF 6?
  •  
mikeonline

Messages: 6
Karma: 0
Send a private message to this user
Concerning VPN deploying...
I make Kerio VPN (tunnel & client-server) to work, but only between hosts. LAN behind the firewall is not visible at all. So I have read this forum - that is not only my trouble Smile
So the manual about windows VPN (PPTP) said I have to permit in my firewall the "IP-address of source/destination network for DMZ interface of VPN server and the IP-protocol identifier set to 47 (0x2F)"

As I understand the traffic rules allow to set permissions for TCP, UDP, ICMP and "other" protocols only.

Does anybody know how to filter IP packets by heading? Or tell what is "other" protocol means? And if I set "other" protocol number equal to O, assuming IP - how to filter the heading?

[Updated on: Mon, 28 June 2004 09:06]

Previous Topic: strange problem
Next Topic: how to filter IP identifier in KWF 6?
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Fri Nov 24 14:19:49 CET 2017

Total time taken to generate the page: 0.00323 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.