Home » Kerio User Forums » Kerio Control » How to set Metric for VPN Tunnel Custom Routes?
  •  
maa1

Messages: 90
Karma: -27
Send a private message to this user
How to set Metric for VPN Tunnel Custom Routes?
  •  
maa1

Messages: 90
Karma: -27
Send a private message to this user
  •  
maa1

Messages: 90
Karma: -27
Send a private message to this user
Any comments from support?
Or its dead forum?
  •  
Zaw Min

Messages: 2
Karma: 0
Send a private message to this user
Yes. I need to set the custom route matrix too. Please, someone give some solution!
  •  
chrisgi

Messages: 9
Karma: 0
Send a private message to this user
Hello,

I've seen metric goes to 10 when you use Load Balancing....

But i'm also wondering how i can set up ?

If GFI/Kerio support is here, please give us a little answer Wink

Regards,

Chris
Previous Topic: Hardware Specs
Next Topic: does https cache applies on https traffic ?
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Nov 17 11:50:11 CET 2018

Total time taken to generate the page: 0.82517 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.