Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Backup/Restore
  •  
nhoague

Messages: 853
Karma: 18
Send a private message to this user
So, I had a customer yesterday with a Control appliance that finally gave up. We have a spare Control box at the office, so we ran it down to the site, got it all connected and then tried to restore the backup file (from Samepage!).

While the backup file downloaded just fine, we ran into a problem with the interfaces. Luckily I know their static IP information cause none of that imported. All the users and rules imported just fine.

So question is ... what are we supposed to expect when restoring from a backup file on the Interfaces. I expected all the IP's, gateway, DNS, etc to be a piece of cake.

Also, the LAN IP didnt change, but the DHCP scope did! That was a doozy. Smile

Thoughts?

Previous Topic: Problem with IPSec
Next Topic: no ping kerio
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Fri Aug 18 22:08:09 CEST 2017

Total time taken to generate the page: 0.00342 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.