Home » Kerio User Forums » Kerio Control » IPSec VPN and static address

Messages: 25
Karma: 0
Send a private message to this user
I need to use an IPSec VPN (KC 8.1.1 patch 1 build 1019) with static IP address on the client side. Does KC support this scenario?.

Thank you.
Neil Whiteside (Kerio)

Messages: 318

Karma: 35
Send a private message to this user

Yes, that configuration should work fine.

This KB article should help:


Best regards,


Knowledge Base: http://kb.kerio.com/.
Looking for technical support? http://www.kerio.com/support
Previous Topic: How can I take the traffic of emails from the quota?
Next Topic: How can i access the internet throw IPSEC
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Tue Nov 20 20:52:56 CET 2018

Total time taken to generate the page: 0.98515 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.