Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » More than 2GB RAM
  •  
Twin

Messages: 3
Karma: 0
Send a private message to this user
Hello there.

Why Kerio Control Software Appliance does not see more than 2GB of RAM ?
  •  
rjokl

Messages: 64
Karma: 7
Send a private message to this user
Hello,
it i because of disabled PAE in the kernel. Should work since 8.2.0 beta.

Regards,
Roman Jokl
  •  
Twin

Messages: 3
Karma: 0
Send a private message to this user
Thank you very much for your answer, really in the description of the changes beta release Changes in 8.2.0 Beta 1 - "PAE was enabled in Linux kernel, more than 4GB of RAM are now detected".
Fine.
Previous Topic: Viber
Next Topic: Routing single website through VPN client
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Oct 21 06:40:32 CEST 2017

Total time taken to generate the page: 0.00389 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.