Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » The same HW 7.4->8.x migration
  •  
paja

Messages: 9
Karma: 0
Send a private message to this user
I'm planning the migration from Windows 2003 based Kerio Control 7.4.2 to 8.x software appliance. The HW is old, rock-fest Dell 2950 server. I didn't find any HW reference list for software appliance deployment, so I'm not sure about HW compatibility.
Is the first boot from the medium destructive? Will I loose the Windows based installation when I have no success to run new 8.x admin interface over the network due to some incompatibility (NIC, RAID....)?
Previous Topic: Show the real NAT(ed) source on the destination
Next Topic: Unable to complete pppoe discovery
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Mon Nov 20 10:50:59 CET 2017

Total time taken to generate the page: 0.00339 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.