Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Connect » Network interface configuration
  •  
philipp_hauser

Messages: 23
Karma: 0
Send a private message to this user
Hi there,

i'm currently setting up a kerio connect mailserver on a SuSe system with 2 network interfaces.

Interface eth0 should be used to communicate with the clients in the internal network.
Interface eth1 should be used to communicate with the external mail provider (strato).

Is it possible to configure the kerio mailserver to use interface eth0 for the internal communication (imap) and interface eth1 for the external communication (pop3)
  •  
Pavel Dobry (Kerio)

Messages: 5245
Karma: 251
Send a private message to this user
Kerio Connect uses network interfaces as configured in network routing table. Ie. for local addresses it uses interface with local IP address, for accessing the Internet it uses interface with default gateway. There is no setting required. Operating system do it automatically.
Previous Topic: Resource Free/Busy information
Next Topic: Sophos issues - any other solutions?
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Mon Aug 21 15:54:52 CEST 2017

Total time taken to generate the page: 0.00419 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.