Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Trusted interface additional IP addresses
  •  
credo

Messages: 14

Karma: 0
Send a private message to this user
Hello,

Is there any limitations of to add 3-5 additional subnets to internal trusted interface (primary subnet is 10.3.3.0/24, added are 10.3.4.0/24, 10.3.5.0/24 and 10.3.6.0/24.
I see that system makes all routes as needed but the devices configured to use new subnet IP's have difficulties to access resources in 10.3.3.0/24 subnet.

Thanks,
Mati
  •  
silars

Messages: 429
Karma: 59
Send a private message to this user
If you went to a /22 mask and started at 10.4.0.0/22, you wouldn't need to worry about subinterfaces. You could also do /21 and have 10.0.0.0-10.7.255.255 available.

The best answer would depend on your subnet arrangement. Proper selection of networks allows you to gain the full benefits of CIDR addressing. It also greatly simplifies routing tables, DHCP scopes, packet flow, etc.
Previous Topic: User Statics are Shown as UNRECOGNIZED USERS
Next Topic: Problem with Active directory
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Tue Oct 17 18:49:13 CEST 2017

Total time taken to generate the page: 0.00401 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.