Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Error installing Kerio Control 8.2.2
  •  
Gamaliaka

Messages: 5
Karma: 0
Send a private message to this user
Hi.
I want install Kerio from usb, but during installation an error:
"Hard Drive Not Found"(Screenshot - i.imgur.com/iRcMJ1z.jpg)

Go to Alt + F2
lspci -v (Screenshot - i.imgur.com/4zWkwYd.jpg)

04:02.0 Raid bus controller: Adaptec AAC-RAID (rev 01)
Subsystem: Adaptec 2120S (Crusader)
Flags: bus master, 66MHz, slow devsel, latency 64, IRQ 52
Memory at f8000000 (32-bit, prefetchable) [size=64M]
Expansion ROM at fe9f0000 [disabled] [size=64K]
Capabilities: [80] Power Managment version 2
Kernel driver in use: aacraid

cfdisk (Screenshot - i.imgur.com/kbwfbDQ.jpg)

Server Configuration:
Supermicro X5DPA-GG
4x512Mb PC2100 DDR Registered ECC DIMM
2 Intel Xeon 2,44GHz
Controller - Adaptec 2120s
3xFujitsu MAP3367NP 36,7Gb - Raid5

What am I doing wrong?
  •  
Vicky

Messages: 656

Karma: 82
Send a private message to this user
Hi Gamaliaka,

Have you gone to the following URL yet to check the hardware compatibility:

http://kmuto.jp/debian/hcl/

We use a debian based linux for our software appliance, the link above will allow you to check if your hard has any known issues with the kernel we use.

Give this a go and just check that there isn't a know issue with the hardware you are trying to use.

All the best,
Vicky
  •  
Gamaliaka

Messages: 5
Karma: 0
Send a private message to this user
My hardware is supported (Screenshot - i.imgur.com/5ufOMZ8.jpg)

I created installations USB flash disk by Unetbootin
(FAQ - kb.kerio.com/product/kerio-control-ru...)

Now I created installation USB flash disk by Image Writer
(FAQ - manuals.kerio.com/control/adminguide/en/sect-usbflash.html)

New Error in installation:

Hard Drive Is Too Small
ERROR: The hard drive in this computer is too small. At least 2957 MB is required. The installation cannot continue.

[Updated on: Wed, 26 February 2014 10:41]

  •  
mlee (Kerio)

Messages: 246
Karma: 16
Send a private message to this user
It seems like your RAID controller is not supported.

M.

PTSD. BP. OCD. ASPD. BPD. Certified.
  •  
Gamaliaka

Messages: 5
Karma: 0
Send a private message to this user

Once installed on a different drive, Kerio sees the raid and can work with him. Debian supports this controller:
The last line - "Adaptec - AAC-RAID - yes"
Kerio can be installed on the RAID?
What controllers can work with Kerio?
  •  
mlee (Kerio)

Messages: 246
Karma: 16
Send a private message to this user
You can click on the link under the Software Appliance area of the following URL and check if your RAID controller is supported:
http://www.kerio.com/control/technical-specifications

PTSD. BP. OCD. ASPD. BPD. Certified.
  •  
Gamaliaka

Messages: 5
Karma: 0
Send a private message to this user
Martin Lée (Kerio) wrote on Fri, 28 February 2014 03:53
You can click on the link under the Software Appliance area of the following URL and check if your RAID controller is supported:
kerio.com/control/technical-specifications

My RAID controller is supported:
PCI ID Works? Vendor Device Driver Kernel
90050285 Yes Adaptec AAC-RAID aacraid v2.6.25-
  •  
Gamaliaka

Messages: 5
Karma: 0
Send a private message to this user
Previous Topic: NAT problem
Next Topic: Routing all client traffic through the VPN
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sun Oct 22 06:44:45 CEST 2017

Total time taken to generate the page: 0.00428 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.