Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Bonding Ethernet Interfaces
  •  
tidusquall

Messages: 2
Karma: 0
Send a private message to this user
Hello,
I have juste installed the latest version of Kerio Control Software Appliance. Now I would like to know how I can bond two local interfaces.
Before Kerio was installed on a Windows Server 2008, so the bonding was easily feasible by the networking driver but with the new OS version I don't know what to do.
Think
  •  
ICT and Me

Messages: 936

Karma: 53
Send a private message to this user
Can only be done if you use first VMware ESXi Hypervisor for example.
As far I know Control doesn't support this.
With VMware you can place to physical nic's on one virt.switch and connect control to the same switch. That is the only way.

ICT and Me
Carlo Turk
The Netherlands
www.ictandme.nl
  •  
tidusquall

Messages: 2
Karma: 0
Send a private message to this user
Ok. I will try with WMWare ESXi version and keep you informed.
Thank you!
Previous Topic: Reverse proxy problems
Next Topic: Keriol Control - SIP problem
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Aug 19 11:12:24 CEST 2017

Total time taken to generate the page: 0.00403 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.