Home » Kerio User Forums » Kerio Control » Kerio Control replies to any arp-request on any interface?

Messages: 22

Karma: 4
Send a private message to this user
It looks like Kerio Control replies to any arp-request it gets, whether the requested interface is configured for that address or not.

In my case, a second interface in the same vlan causes my routers to send traffic to the wrong interface, because Kerio Control responds to arp-requests for interface A with the mac-address of interface B.

This can be tweaked with the sysctl arp_ignore-switch: http://kb.linuxvirtualserver.org/wiki/Using_arp_announce/arp _ignore_to_disable_ARP

Please do so.

Offering Kerio and much more. See http://www.tuxis.nl and http://www.kerioindecloud.nl/
Previous Topic: Disabling an interface does not shut the interface
Next Topic: cmd code
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Dec 15 20:07:03 CET 2018

Total time taken to generate the page: 1.11707 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.