Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » bandwidth management and qs (limited per user problem)
  •  
mbat

Messages: 1
Karma: 0
Send a private message to this user
hello
I cannot limit bandwidth per user or per ip on user group or ip group.
Kerio control set for whole of them.
please help me Confused
  •  
Vicky Tripp (Kerio)

Messages: 630

Karma: 81
Send a private message to this user
Hi Mbat,

I think looking at our KB article for bandwidth management may help you understand what can and cannot be achieved with bandwidth management:

http://kb.kerio.com/1334

The KB shows you can set a user or user group but you cannot set an IP address.

All the best,
Vicky

Vicky Tripp
Kerio Technical Support Engineer
Previous Topic: Kerio Control install D-Link DWA-125
Next Topic: What is the Maximum Bandwidth of Hyper-V Edition?
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sun Feb 26 06:30:04 CET 2017

Total time taken to generate the page: 0.01059 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.