Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Multiple network interfaces (Kerio Control )
  •  
George Williams

Messages: 1
Karma: 0
Send a private message to this user
I am in the process of setting up a new control box. I have set 3 of the interfaces up individually, they are all under the Trusted / Local Interfaces and each has a separate IP of 192.168.10.254, 192.16811.254 & 192.168.12.254.
I have also setup a DHCP server for each of the interfaces again these have the same IP ranges as assigned to the interface, so for example;
192.168.10.11 to 192.168.10.240
Gateway: 192.168.10.254
DNS: 192.168.10.254

The Gateway and DNS for different for each IP range, so for example the second interface of 192.168.11.x has a Gateway configured of 192.168.11.254 and a dns server of 192.168.1.254

I can ping find between pc's on the different IP ranges however I am unable to ping to the host name. If you run the commands from within the control it can resolve both the IP address and host name.
Any help would be greatly appreciated
  •  
mlee (Kerio)

Messages: 246
Karma: 16
Send a private message to this user
I am guessing you mean using DNS Server 192.168.11.254 in the second paragraph.

Do you see the hostnames under DHCP? Can you ping hostnames within the same subnet? Or only having issues with DNS across subnets?

Some tools we recommend for troubleshooting DNS issues would be nslookup (Yeah I am oldschool) and dig.

To get extra info, you can enable DNS messages under decoded protocols in debug log.

M.

PTSD. BP. OCD. ASPD. BPD. Certified.
  •  
GMarciales

Messages: 8

Karma: 0
Send a private message to this user
Hi.

George, remember to work well DNS you need a DNS server capable to support DDNS, from Windows 2000 to present all Microsoft Server OS support this feature, create zone for each name example vlan01.com, vlan02.com..., each one with him respective reverse zone.
Assuming your clients are Microsoft Win, personally I always set disable NETBIOS over IP ( IPv4), LMHOST and I check two options on DNS tab to make mandatory the client write A HOST in DNS.

About DHCP server, we can send commands over DHCP, like NTP, TFTP, routes... the DDNS, if you need more support about the DHCP options please let me know.

Please always remember send DOMAIN NAME with the same name like the DNS zone to complete FQDN.

Try from different VLAN send PING -a "IP ADDRESS" to check reverse resolution.

Regards.
Previous Topic: Software Appliance under Hyper-V
Next Topic: Kerio Control 8 support SNMP monitoring?
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Thu Jul 20 14:38:46 CEST 2017

Total time taken to generate the page: 0.00380 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.