Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » windows 7 pcs do not see kerio routing table (routing)
  •  
Kerio Blue

Messages: 62
Karma: 5
Send a private message to this user
Hi everyone,

Some of my users need to connect to a remote server via RDP. To do so we are using another gateway device which sets up a permanent VPN tunnel.

I have added a route on the Kerio firewall so that the tunnel could be used from all workstations on the network.

However, this setup only works on Macs. With Windows 7 (I have not tested with Windows 8.x) the connection either fails or the sessions will be disconnected every 20 seconds or so. If I add a persistent route on the Windows machine everything works just fine. This should rule out the VPN connection as a culprit.

Is there anything I have to do on the machines to make them recognize the routing table or is it something on the Kerio side? Any advise?

Previous Topic: Interface configuration
Next Topic: Internet Weight Link Configuration
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Mon Oct 23 22:43:59 CEST 2017

Total time taken to generate the page: 0.00449 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.