Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Bandwidth Management rule for VoIP don't work
  •  
maa1

Messages: 144
Karma: -27
Send a private message to this user
Hello,

I have two offices and a VPN-tunnel between them (Kerio Control 8.6).
In office1 i have SIP-PBX, in office2 i have SIP-phone.
In "Bandwidth Management and QoS" i set rule with Traffic Type = SIP VoIP, reserve 512 kbit/s, and check Chart.


But, when i call from phone to PBX, rule don't work!

  •  
ksnyder

Messages: 557
Karma: 36
Send a private message to this user
I believe this is because your traffic is perceived as VPN traffic rather than SIP in this case. You can test this by doing the following:

1. Status-->Active Hosts-->[Choose your VPN user]
2. View the "Connections" tab
3. Place a test phone call from office 2 SIP phone
4. Observe the entry in "Bandwidth Management Rule" column (display it if it's not already). It's likely to be blank/empty.

If your SIP QoS rule is not being applied, then add VPN to the Traffic Type in your QoS rule and then repeat the 4 steps above. You should now see that QoS rule being applied during your phone call.

You might, ultimately, decide to simply prioritize VPN traffic within QoS as a matter of practice.

[Updated on: Wed, 08 July 2015 18:51]


Ken Snyder
  •  
maa1

Messages: 144
Karma: -27
Send a private message to this user
I hope this bug will be fixed soon.
(i not need reserve all VPN traffic, i need reserve only voice traffic)
  •  
ICT and Me

Messages: 927

Karma: 53
Send a private message to this user
I want to point out this is not a bug.
QoS for SIP is mentioned on WAN ports.
VPN tunnel is NOT a WAN port. So use the VPN QoS like Ken has mentioned.

If you take a good look at the QoS management you can see you can't select other interfaces the only the WAN interfaces.

ICT and Me
Carlo Turk
The Netherlands
www.ictandme.nl
Previous Topic: VPN Client Service not running
Next Topic: cant connect to server
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sun Mar 26 00:37:36 CET 2017

Total time taken to generate the page: 0.00368 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.