Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Operator » Caller ID FXO Detection in Czech Republic (Caller ID FXO Detection in Czech Republic)
  •  
jarynzjarynova

Messages: 2
Karma: 0
Send a private message to this user
Hello, I would like to ask you how to correctly setup the FXO interfaces to recognize the Caller ID of incoming calls?

What are the parameters?

Thank you for your advice.

Jaromir
  •  
Vladimir Toncar (Kerio)

Messages: 1696
Karma: 39
Send a private message to this user
You must first ask the telco to send you the Caller ID, the service is off by default.

The Caller ID should be sent as a Bell-encoded string between the 1st and the 2nd phone ring. Hence the Operator config is follows:

Caller ID signalling: bell
Caller ID start: ring

If Bell enconding does not work for you, try v23.
Previous Topic: Cannot Connect to Firebird Database
Next Topic: Pickup a ring group
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Mon Mar 27 22:25:15 CEST 2017

Total time taken to generate the page: 0.02472 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.