I just installed 6.0.4 on an windows xp pro machine with sp2. Yes, I have turned off ICS. Yes, I did run the configuration wizard and have the following policies:
Firewall==>Any Allow Ping
PrivateLAN==>PublicLAN Allow Any with NAT
Firewall==>Any Allow Any
PlublicLAN==>Firewall Allow Ping
Any==>Any Drop Any
When I run a scan from GFI Lananalyzer or NMAP
I get one port (110) still showing as open!!!!
Does anyone have any idea what is going on???
Since my publicLAN (10.1.8.*) is not directly on the net, I can't run GRC or a web based scanner.
Here is the NMAP out put from 10.1.8.1 (nmap machine) to 10.1.8.3 (the win xp sp2 kerio firewall machine).
Thanks in advance for your help.
C:\temp\test\nmap>nmap -vv -sT -p 1-1090 -P0 -T 5 10.1.8.3
Starting nmap 3.70 ( http://www.insecure.org/nmap ) at 2004-09-13 00:42 Eastern Daylight Time
Initiating Connect() Scan against 10.1.8.3 [1090 ports] at 00:43
Discovered open port 110/tcp on 10.1.8.3
The Connect() Scan took 49.25s to scan 1090 total ports.
Host 10.1.8.3 appears to be up ... good.
Interesting ports on 10.1.8.3:
(The 1089 ports scanned but not shown below are in state: filtered)
PORT STATE SERVICE
110/tcp open pop3
Nmap run completed -- 1 IP address (1 host up) scanned in 53.938 seconds
[Updated on: Mon, 13 September 2004 06:49]
Kerio discussion forums are intended for open communication between forum
members and may contain information and material posted by members which may
be useful in learning about Kerio products. The discussion forums are not
intended to provide technical support for any specific product. Any
information implied or expressed in the discussion forums is that of the
posting member. Kerio is in no way responsible for the information posted in
the forums, or its accuracy. Kerio employees may participate in the
discussions, but their postings do not represent an offical position of the
company on any issues raised or discussed. Kerio reserves the right to
monitor and maintain the forums to promote free and accurate exchange of