Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Kerio Control and Withings WS-50
  •  
jassu

Messages: 27
Karma: 0
Send a private message to this user
After installing Kerio Control to my network my Withings ws-50 smartscale stopped working.

I have now 2 nights debugged that and from the logs i can see that theres allowed traffic going through the control-box - no filtering is seen from logs as far as i can know.

I have tried to add withings ip-network to allow all section and also intrusion prevention has been switched off etc.

When i change my withings to my temporary 4G wlan everything works like a charm again, but through kerio control it is not working.

Anyone else have problems with Kerio Control & Withings?
  •  
Brian (GFI/Kerio)

Messages: 780
Karma: 79
Send a private message to this user
Refer to my advice regarding Protocol Inspection in your other post http://forums.kerio.com/m/129294/#msg_129294
The issue is likely related to the HTTP inspection. You can create a special traffic rule to allow HTTP from that device to a specific remote location, and to exclude inspection. Don't forget to configure source NAT on the rule.

Brian Carmichael
Instructional Content Architect
  •  
jassu

Messages: 27
Karma: 0
Send a private message to this user
Ok, heres solution if someone else is also having problems with Withings.

Withings is using c-block 89.30.121.0/24. Using the Kb-article provided by Brian turn the inspection of from that network. After that scale start to work again.

[Updated on: Fri, 29 April 2016 20:34]

Previous Topic: Turn Off Firewall
Next Topic: VPN tunnel and VPN server
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Wed Nov 22 21:23:10 CET 2017

Total time taken to generate the page: 0.00359 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.