Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Kerio Control + ESXi 6 free

Messages: 1
Karma: 0
Send a private message to this user
i'm trying to run Kerio Control 9 under ESXi 6 on Dell PowerEdge R430 server

after installing and reboot Kerio stucks with message "Kerio Control Engine is starting up"

on pressing ALT+F4 seems like i get /var/message out and its informing every 1-2 seconds:
kipf!netdev_event():6 'kvnet', if_index 4, refcnt10, dev ebc4a800, mac ........, mtu 1400
kipf!netdev_event(): net device event 0x0011 on dev 'kvnet' signaled

if i try change IP settings from kerio console, then get error "error with communication with engine"

plz help anybody!

[Updated on: Sun, 21 August 2016 12:56]

Previous Topic: Kerio Control statistics
Next Topic: Serial Number in 2 installations
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Thu Jan 19 22:37:40 CET 2017

Total time taken to generate the page: 0.00828 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.