Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » PPPoE connective problem
  •  
man 1972

Messages: 1
Karma: 0
Send a private message to this user
Hi,

Sorry for bad English.

I'm from vietnam
I have 2 wan configuration (different ISP) using PPPoE protocol (FTTH) to run load balancing. However 1 WAN by an ISP is always the "connective problem" whether I have to change to another network card. With the "connective problem" it can not transmit data WAN though still connected.
I suspect the fault is due to ISP. I have contacted the ISP but they said they had checked and found still connected network.
Please help explain the above error is what? How to fix.
Thanks for the help
  •  
Goran

Messages: 326
Karma: 5
Send a private message to this user
Are you use the same gateway on 2 internet nic?

Question cannot be stupid, but some of the answers can.
Previous Topic: Joining in network Domain
Next Topic: After update to 9.1.3, Problem with default gateway
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sun Dec 11 14:48:58 CET 2016

Total time taken to generate the page: 0.00727 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.