Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » Slow HTTPS access to DMZ (Access Kerio Control in DMZ via HTTPS is very slow)
  •  
weidl

Messages: 1
Karma: 0
Send a private message to this user
Hi,
I just configured a new NG500 and have a problem with accessing the Kerio Connect Server in DMZ via https. It takes serveral seconds (6-10) until the login appears. This does not happen with the old Firewall.

The config is:

WAN: multihoming with 5 addresses
DMZ: 192.168.2.1
Kerio Control: 192.168.2.3

Policies:
WAN_2_Mail: Source: Any, Dest: Mail-WANIP, Service: HTTPS and others, Action: allow, MAP to 192.168.2.3
Mail_2_WAN: Source: 102.168.2.3, Dest: Internetadapters, Service: HTTPS and others, Action: allow, Source-NAT Mail-WANIP
DMZ_2_WAN: Source: DMZ, Dest: Internetadapters, Service any, Action: allow, NAT

Does any one have an idea where to look for this?

Thanks
Previous Topic: And Two Content rules
Next Topic: Hardware requirements for Software Appliance
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Thu Mar 30 22:31:38 CEST 2017

Total time taken to generate the page: 0.00369 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.