Home » Kerio User Forums » Kerio Control » Dual WAN - Traffic Routing (How to route specific traffic types per WAN Interface?)

Messages: 4
Karma: 0
Send a private message to this user
I have a customer who is running Kerio Control 9.2.1 at two offices connected via Kerio VPN tunnel. At the main office, they want to add a second Internet feed and configure the Kerio Control box for dual WAN.

Rather than configure the dual WAN for load-balancing or failover mode, they would like to route all of the site-to-site VPN traffic over WAN2 while all other incoming and outgoing traffic uses WAN1.

Both WAN interfaces have static IP and I can effectively set the tunnel endpoint on the remote side to use one or the other, which ensures the VPN traffic uses the correct interface. I'm wondering what else needs to be done to configure this correctly for what they want?

Any thoughts most appreciated.

[Updated on: Wed, 08 February 2017 22:05]

Previous Topic: Apply Bandwidth Mgt. to a specific interface?
Next Topic: How to block video streaming in facebook
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Wed Nov 14 13:55:30 CET 2018

Total time taken to generate the page: 1.18296 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.