Home » Kerio User Forums » Kerio Operator » Netmask issue (Unable to make permanent changes stick)
FJ Consultant

Messages: 3
Karma: 0
Send a private message to this user

I need to make an unusual IP configuration to the Operator appliance. It needs a /32 subnetmask with an explicit route.

Unable to do such configuration on the "orange" shell console, I logged in the Linux and made the configuration.

ipconfig eth0 x.x.x.x netmask
route add ... ...
route add default gw .. ...

At this point, all is good. The appliance works. It's 100% network operational. The web-admin portal is also fine.

The problem: the changes made on the command prompt don't stick across a reboot.
Previous Topic: GXW410X OUTGOING CALLS
Next Topic: Grandstream 2160
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Fri Jan 18 06:55:19 CET 2019

Total time taken to generate the page: 0.73648 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.