Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » IPsec lifetime (What is the IPsec Lifetime and how to change?)

Messages: 8
Karma: 0
Hi there,
what is the default value for the IPsec lifetime in Phase 1 and Phase 2?
I found this paper: ing-ipsec-vpn-tunnel-kerio-control-and-another-device-1390.h tml
with these values:
phase1: 10800
phase2: 3600

Is this true?

And is there any way to change these values?

I have to setup a tunnel to another location and they expect 3600 for both.

Best regards
Previous Topic: Only whatsup
Next Topic: Unstable Tunnel
Goto Forum:

 ] [ PDF ]

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Jan 20 02:29:20 CET 2018

Total time taken to generate the page: 1.13378 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.