Home » Kerio User Forums » Kerio Control » NG100 Power requirements
  •  
LoudMusic

Messages: 1
Karma: 0
Send a private message to this user
Hello - the NG100 lists 12vDC input as the specified power supply. Is there any margin of tolerance for this device? Thanks!
  •  
Shaunie

Messages: 5
Karma: 0
Send a private message to this user
on the power supply for my NG100 it states:
Input: 100-240Vac 1.2A 50-60Hz

AC Output 12v 3.0A
Uses a positive tip.

I would imagine you could use a different power supply unit of greater capacity. I wouldnt recommend using something with a lower output as its likely to get very hot and possibly cause a fire.
Previous Topic: can not access my wan ip address from lan
Next Topic: Configure Guest interface
Goto Forum:
  


Disclaimer:
Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Wed Nov 14 01:02:21 CET 2018

Total time taken to generate the page: 1.72514 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.