Connect. Communicate. Collaborate. Securely.

Home » Kerio User Forums » Kerio Control » smtp and pop3 problem

Messages: 7
Karma: 0
Send a private message to this user
Hi, I'm using Kerio 6.1, and I already set my http policy.
The problem now is , I can't send and receive email to my PC.

In another topics, said that I have to disable inspector protocol on SMTP and POP3.
Where I have to disable the inspector protocol? in the traffic policy or in services?

If I disable Inspector Protocol in traffic policy, then I can't filter the web access.

Need Help,, ASAP.


Messages: 2119
Karma: 3
Send a private message to this user
You should 'split' the Traffic Policies for web protocols and mail protocols. Make a seperate Traffic Policy for eacht type of traffic. As such, you can enable protocol instepctors for the web (HTTP(S)) and disable them for mail (POP3, IMAP(S), etc.)

(Different discussion: mail should work just fine with protocol inspecptors enabled... Disabling them is ok, but then the mail won't get virus scanned, etc.)
Previous Topic: FTP Rules and winroute 4.2.5
Next Topic: permit certain web site and deny the rest
Goto Forum:

Kerio discussion forums are intended for open communication between forum members and may contain information and material posted by members which may be useful in learning about Kerio products. The discussion forums are not intended to provide technical support for any specific product. Any information implied or expressed in the discussion forums is that of the posting member. Kerio is in no way responsible for the information posted in the forums, or its accuracy. Kerio employees may participate in the discussions, but their postings do not represent an offical position of the company on any issues raised or discussed. Kerio reserves the right to monitor and maintain the forums to promote free and accurate exchange of information.

Current Time: Sat Nov 25 01:02:41 CET 2017

Total time taken to generate the page: 0.00380 seconds
.:: Contact :: Home ::.
Powered by: FUDforum 3.0.4.